Posts for: February, 2017
Drilling teeth is an essential part of repairing and restoring the damage caused by tooth decay. For generations dentists have relied on the dental drill with its rotating burr to remove decayed and damaged tooth material.
But while the dental drill is effective it also has its disadvantages. In the process of removing decayed material it inadvertently removes healthy structure near the target material. It often requires anesthesia to deaden the work area. And its noise and vibration are often unsettling to patients.
There is a growing alternative, though: air abrasion, a technology that's been around since the mid-20th Century. But recent advances in controlling the dust created by using abrasion, as well as new tooth-colored bonding materials to replace tooth structure, have sparked new interest among dentists and patients alike.
Also known as particle abrasion, this drill alternative uses a pressurized stream of fine particles to remove decayed material. Using a hand wand a dentist can precisely aim the stream of particles (usually aluminum oxide) to the specific areas of decay or softened material that need to be removed. As a result, it removes only a fraction of healthy tooth structure compared to traditional drilling. Air abrasion has also proven effective for removing staining without harming enamel.
Air abrasion also eliminates the sound and vibration associated with dental drills, and may not always require local anesthesia. On the other hand, it does have some limitations. For one, it's not as effective with larger cavities or working around older fillings. The tooth or teeth to be worked on must be carefully isolated from the rest of the mouth to keep the patient from swallowing the abrasive particles. And without a high-volume suction pump and good isolation protocols, the particles can produce something of a “sandstorm” in the treatment room.
But as air abrasion continues to advance, we may see improvements in these limitations. In a future time, the traditional dental drill may go the way of the horse and buggy.
If you would like more information on air abrasion as an alternative to drilling, please contact us or schedule an appointment for a consultation. You can also learn more about this topic by reading the Dear Doctor magazine article “Air Abrasion Technology.”
Everyone loves a concert where there's plenty of audience participation… until it starts to get out of hand.Â Recently, the platinum-selling band Fifth Harmony was playing to a packed house in Atlanta when things went awry for vocalist Camila Cabello. Fans were batting around a big plastic ball, and one unfortunate swing sent the ball hurtling toward the stage — and directly into Cabello's face. Pushing the microphone into her mouth, it left the “Worth It” singer with a chipped front tooth.
Ouch! Cabello finished the show nevertheless, and didn't seem too upset. “Atlanta… u wild… love u,” she tweeted later that night. “Gotta get it fixed now tho lol.” Fortunately, dentistry offers a number of ways to make that chipped tooth look as good as new.
A small chip at the edge of the tooth can sometimes be polished with dental instruments to remove the sharp edges. If it's a little bigger, a procedure called dental bonding may be recommended. Here, the missing part is filled in with a mixture of plastic resin and glass fillers, which are then cured (hardened) with a special light. The tooth-colored bonding material provides a tough, lifelike restoration that's hard to tell apart from your natural teeth. While bonding can be performed in just one office visit, the material can stain over time and may eventually need to be replaced.
Porcelain veneers are a more long-lasting solution. These wafer-thin coverings go over the entire front surface of the tooth, and can resolve a number of defects — including chips, discoloration, and even minor size or spacing irregularities. You can get a single veneer or have your whole smile redone, in shades ranging from a pearly luster to an ultra-bright white; that's why veneers are a favorite of Hollywood stars. Getting veneers is a procedure that takes several office visits, but the beautiful results can last for many years.
If a chip or crack extends into the inner part of a tooth, you'll probably need a crown (or cap) to restore the tooth's function and appearance. As long as the roots are healthy, the entire part of the tooth above the gum line can be replaced with a natural-looking restoration. You may also need a root canal to remove the damaged pulp material and prevent infection if the fracture went too far. While small chips or cracks aren't usually an emergency (unless accompanied by pain), damage to the tooth's pulp requires prompt attention.
If you have questions about smile restoration, please contact us and schedule an appointment. You can read more in the Dear Doctor magazine articles “Porcelain Veneers: Strength & Beauty As Never Before” and “Porcelain Crowns & Veneers.”